Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

fire pit

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • fire pit

    Hello folks I need help , I made a fire pit out of 1/4 " plate 3 sides with expanded metal one is solid a 8 " stack I would like to add glass to the open sides to control heat better any ideas?

  • #2
    Post a pic.

    Comment


    • #3
      No picture. It did not happen?

      Comment


      • #4
        Try this site:

        http://www.fastreplacementglass.com/...s-11-inch.html

        The pyroceram should be mounted or attached loosely so it can expand and contract with temp changes without breaking.

        good luck and please post photos

        Comment


        • #5
          fire pit

          Sorry fellows I have a hard time with computers will post pic as soon as I can figure it out

          Comment

          Working...
          X
          Special Offers: See the latest Miller deals and promotions.