Announcement

Collapse
No announcement yet.

aluminum driveshaft, check

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • aluminum driveshaft, check

    So I was able to do an aluminum drive shaft, I looked up how to do it and it seemed pretty easy.

    Now before you start, this was only to move the truck from his house to the paint and body shop. I told him it was not balanced and also it was not rated for high horsepower. The job over all was pretty easy, the hardest part was making sure the metal was clean enough to weld on. I charged him 100 for the rush job and another 40 for the brackets I extended. over all job came out nice.

    Last edited by nrhmarine7; 12-01-2013, 08:07 PM.
    syncrowave 250
    millermatic 140 with spool gun
    350 dully with 225
    spectrum 375
    lateral band saw
    14in vertical band saw
    14in cold cut saw
    and now a 24x40 shop

    ALL THE STUFF I HAVE BUILT

    www.facebook.com/studiostevens

  • #2
    I'm assuming you shortened the driveshaft? If so what is it going into? Did you tig it?

    The spring hangers look pretty long, did you add extra braces to help with flex?
    MM250
    Trailblazer 250g
    22a feeder
    Lincoln ac/dc 225
    Victor O/A
    MM200 black face
    Whitney 30 ton hydraulic punch
    Lown 1/8x 36" power roller
    Arco roto-phase model M
    Vectrax 7x12 band saw
    Miller spectrum 875
    30a spoolgun w/wc-24
    Syncrowave 250
    RCCS-14

    Comment


    • #3
      Originally posted by MMW View Post
      I'm assuming you shortened the driveshaft? If so what is it going into? Did you tig it?

      The spring hangers look pretty long, did you add extra braces to help with flex?
      Yes, I shortened the driveshaft, using gtaw. The drive shaft is going in an all wheel drive truck. The extended braces had no room in the middle but the frame its self will be between the ends.
      syncrowave 250
      millermatic 140 with spool gun
      350 dully with 225
      spectrum 375
      lateral band saw
      14in vertical band saw
      14in cold cut saw
      and now a 24x40 shop

      ALL THE STUFF I HAVE BUILT

      www.facebook.com/studiostevens

      Comment

      Working...
      X