Announcement

Collapse
No announcement yet.

ring roller

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • ring roller

    Hi I was thinking about building a ring roller and I was thinking about what size bottle jack I will need.I will be doing a maximum of 3/4" round and square stock.And I will be doing a maximum of 4" by 1/4" flat.But I will be doing a large amount of 2" by 3/8" flat.Thanks.
    Stickwelds

    millermatic 251
    thunderbolt xl
    hypertherm powermax 380
    jet bandsaw
    delta chopsaw

  • #2
    me too

    I've been thinking about building a bender too only I'm leaning toward building one like a Milliken (millikendistribution.com). They go for like $4,000 so I figured I'd save a few bucks and make one only maybe a bit cruder in all likelyhood. What kind are you going to build? They sell some pretty cheap ones at Harbor Frieght but I am unsure of it's quality. I'm also looking to come up with a lever operated punch to cut 1/2" square holes for railing ballisters. The only one I've seen so far was in a Northern tools catalog. Seen any anywhere else? Sorry, I don't know about sizing jacks.
    Last edited by envano; 08-15-2007, 08:40 AM.

    Comment

    Working...
    X