I decided to take on a big project...building a trailer. It's a 7X10 with a fold down ramp. I built the side rails low so I could load a couple of ATV's from the side. It is made from 2X3 tubing for the frame and the side rails are 2X2. The floor is 14ga tread plate and the fold down gate is 4' and is made from 1X2 channel iron with mesh wire. It is attached to the framed with barrel hinges. Here it is as of Saturday; I finished the floor and installed the gate. I plan on doing the light brackets/housing. I can't decide if I want the taillights at the back underneath or out to the side up by the rear fender. My plans for finishing is to put a bed liner on the floor and then paint the rest. I'm using my bobcat 225G as a generator to power my Lincoln mig SP 130T using flux core wire.
No announcement yet.
My Utility Trailer