Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

ring roller

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • ring roller

    Hi I was thinking about building a ring roller and I was thinking about what size bottle jack I will need.I will be doing a maximum of 3/4" round and square stock.And I will be doing a maximum of 4" by 1/4" flat.But I will be doing a large amount of 2" by 3/8" flat.Thanks.

  • #2
    me too

    I've been thinking about building a bender too only I'm leaning toward building one like a Milliken (millikendistribution.com). They go for like $4,000 so I figured I'd save a few bucks and make one only maybe a bit cruder in all likelyhood. What kind are you going to build? They sell some pretty cheap ones at Harbor Frieght but I am unsure of it's quality. I'm also looking to come up with a lever operated punch to cut 1/2" square holes for railing ballisters. The only one I've seen so far was in a Northern tools catalog. Seen any anywhere else? Sorry, I don't know about sizing jacks.
    Last edited by envano; 08-15-2007, 08:40 AM.

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.