If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Bob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
Spool Gun conversion. How To Do It. Below. http://www.millerwelds.com/resources...php?albumid=48
Miller Bobcat 225NT onan
(Retapped to fit regular mig tips)
Work better & less parts to stock.
T/A Dragster 85 (portability 11 pounds)
Oxygen/Acetylene torch set 50'
2. 4-1/2" grinders
1. 9" grinder
14" Makita chop saw
1/2" Aircat impact gun 900#
You could add vertical brackets to the ceiling, say a foot in from each side. That would give you an effective 3 foot span. Put a decorative panel or something in the middle that swings/lifts away when you want to do chin-ups. Make it look like part of the decor.