Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Shop press tire bead breaker attachment

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Shop press tire bead breaker attachment

    My Yazoo mower had a flat and i wanted to dismount the tire to add an innertube but i couldn't break the bead. So i dreamed up this little attachment for my shop press. It just slips on my 1" straight bar tooling. Worked great...Bob
    Attached Files

  • #2
    Good idea. I heard those lawn mower tires are tough to break the beads.

    Comment


    • #3
      That is a nifty little device there. Nice. I've oftern just ran over lawn and ATV tires with the truck to break the bead. Lay it down and just run over the tire close to the rim. Worked so far....

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.