Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

20 ton shop press press brake

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • 20 ton shop press press brake

    Howdy folks! New to this site however not new to welding and fabrication. Here are a couple pics of my press brake I fabbed for my Harbor Freight 20 ton shop press. The die is interchangable and right now I have a 12" gooseneck on it. I can bend up to 18" wide. As of now I am comfortable with bending the full width at 1/4" Aluminum. I have gone all the way up to 1/8" Stainless, full width. Ill post more pics later.
    Attached Files

  • #2
    Welcome and nice job...Bob

    Comment


    • #3
      Good to see you and your projects.
      Keep them coming

      Ji

      Comment


      • #4
        Welcome to the forum.

        Comment


        • #5
          Looks nicely made. Very clean and thought out. Welcome to the forum.

          Comment

          Working...
          X
          Special Offers: See the latest Miller deals and promotions.