Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Home made desicant air dryer?

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Home made desicant air dryer?

    I've been thinking of building one...just wondered if anyone has and any suggestions.

    I was going to use an old portable air tank I've got laying around. Mount it to the wall tank ends up and down. Weld a pipe through the side with diffuser holes drilled along its length with the pipe end capped. Weld it close to the bottom of the tank and this would be the air inlet from the compressor.

    The tank has an outlet already at what would be the top side of the tank. I would cut a hole on the top end and weld in a large pipe female fitting. I am thinking of using silica gel cat litter. Its 98% silica and a 12 lb tub is only about 20 bucks. Its not color changing but as best I can tell does the same thing and should be reusable if poured out and heated in an oven at 250.

    Anyway...pour in the cat litter... thread in a pipe plug with Teflon tape to seal it and that should be it. I figure I'll build a stainless wool filter at the outlet as a first pass filter. Then a standard off the shelf air filter and a gauge to monitor any pressure drop.

    I would think 12 lbs will take some time to fully saturate with moisture.

    Any thoughts?

  • #2
    Just research this it really works

    http://route60garage.blogspot.ca/200...anzinator.html

    R

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.