Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Small Kubota bucket

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Small Kubota bucket

    Did this a little while ago. Cut out the old tube, straightened & replacedName:  5275341bb6db57f2ed89ca379b171f7c.jpg
Views: 1
Size:  57.0 KBName:  6cbe5d7615b7c9845844881ebe2ff972.jpg
Views: 1
Size:  53.9 KBName:  5bd08b20d6407a6a49fc92fe005ecb0c.jpg
Views: 1
Size:  54.6 KBName:  bfcef6e5c3221a970e387a239f9f9a70.jpg
Views: 1
Size:  57.8 KBName:  b49ac7c600edbd57ee087f04d96aa31a.jpg
Views: 1
Size:  56.6 KB

  • #2
    Good job!

    Comment


    • #3
      Nice job.... Did you put a beefier bar in?

      Comment


      • #4
        Nice job, I repaired a Bobcat bucket a couple of years ago that had the same damage.

        Comment

        Working...
        X
        Special Offers: See the latest Miller deals and promotions.