Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

welder cart design

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • welder cart design

    I just got my first welder (diversion 165) and I'm going to make a cart for it. As I am looking at pictures of home fab carts and retail ones I see that a lot have the top rack for the welder at an angle sloping back. Is there an advantage to this? Is there something I don't know that I should consider? Any suggestions welcome

    -Tyler

  • #2
    Simply to make the controls easier to see/access when you are standing and the machine is down low.

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.