Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Pig Spit

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Pig Spit

    I want to build myself a pig spit and I have done a bit of digging to find different ideas. Was wondering what you guys had to share? Thanks.

  • #2
    Are you thinking pit, moble tank style or open moble design? My brother built one on a trailer. He used a 400 gal oil tank, cleaned out of course, built the spit with a square socket on the end so the electric drive part can be slid into place when needed. It uses the lower section to hold the coals, its cut down some to feed fire and view hog from a crouch. The top section, hinged, stays down during the cook if you don't mop or spray hog. I haven't been part of or enjoyed a cook (needed repair / mods when I was there), but got a small demo of moving parts and I liked it.
    Last edited by wrench3047; 08-12-2012, 08:54 AM.

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.