Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Aluminum Ramps (car trailer)

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Aluminum Ramps (car trailer)

    Ive been slowly working on these ramps for my car trailer, getting tired of lugging around the heavy steel ramp I have. I should be testing them out this weekend, just have to finish the mount on the trailer. I used a mix of mig and tig, they are made out of 6061 2.5" sqaure tubing 1/8" thick. Not sure of their max capacity but they should work fine for my mustang and most cars. I would have rather of used 1/4" thick tubing but this is what I had available at the time.
    Name:  453ea30df3b3f59e0ef6dd80b1d7dffe.jpg
Views: 1
Size:  104.6 KBName:  37fb52c1688f03c080b8d095709d17f5.jpg
Views: 1
Size:  58.0 KBName:  ea35abff2505d90ea8056357661ddfc6.jpg
Views: 1
Size:  69.2 KB

  • #2
    Looks like those will work good...Bob

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.