Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

exhaust pipe

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • exhaust pipe

    My exhaust pipe fell off right after my catalytic converter on my truck and I only have a stick welder. Any advice or suggestions? Is a stick too heavy for something like this? Thanks

  • #2
    Yes you can use stick but use the smallest rods you can find...Bob

    Comment


    • #3
      exhaust pipe

      Any pipe after the cat any good, slip a pipe over and clamp it.
      Kevin

      Comment


      • #4
        If it is rusty and thin, no hope. But it the metal is good, I've welded plenty with my AC stick welder. It's not easy, but do a little at a time with a small rod and it can be done. I made a full catback system for my superharged Miata.
        CG

        Comment

        Working...
        X
        Special Offers: See the latest Miller deals and promotions.