If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Yes I agree this is not cheating. The older you get the smarter you work.
Is it the picture or is the building dimly lit?
Lincoln ac/dc 225
MM200 black face
Whitney 30 ton hydraulic punch
Lown 1/8x 36" power roller
Arco roto-phase model M
Vectrax 7x12 band saw
Miller spectrum 875
30a spoolgun w/wc-24
The older you get, the more you THINK about how to make the job easier.
When you get my age, you think a LOT.
Syncrowave 250 DX Tigrunner
Dynasty 200 DX
Miller XMT 304 w/714D Feeder & Optima Control
Miller MM 251 w/Q300 & 30A SG
Dialarc 250 AC/DC
Hypertherm PM 600 & 1250
Wilton 7"x12" bandsaw
PC Dry Cut Saw, Dewalt Chop Saw
Milwaukee 8" Metal Cut Saw, Milwaukee Portaband.
Thermco and Smith (2) Gas Mixers
More grinders than hands
My place isn't real bright especially for photographs. I really do need another light there but there are lights on stands and another couple of overheads that were not on.
Get a couple T5 florescent fixtures... bright as **** and much easier on the power bill than metal halides... I can't even remember the last building I built that got halide or mercury vapor bulbs installed....
Last couple lowboys I did, just flipped the whole thing over. Quite a bit of replacing some suspension components, building up other parts, decided it was easier to do looking down rather than looking up. Helps a lot if you have a big forklift, loader, or crane sitting around.
Obviously, I'm just a hack-artist, you shouldn't be listening to anything I say .....