Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Packmaster 50

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Packmaster 50

    Anyone heard of this type of plasma cutter? if so any good? any info would help, thanks. cut size? duty cycle? any info...
    Last edited by Cole; 06-17-2006, 08:24 PM.

  • #2
    pak master 50

    70 is the duty cycle, 1/2" cut capacity, not a bad unit if i do say so. only fall back is it's got a plastic housing.

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.