Announcement

Collapse
No announcement yet.

How do I best cap square steel tuning?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Say your capping 2" square.

    Cut the length of tube 2" longer than needed. Take a portaband and remove three sides of the 2 inches extra.

    Now hammer the remaining tab over and weld around it. Grind and finish.

    Comment


    • #17
      Originally posted by sparky666 View Post
      Go and see welding tipsandtricks ther is a very good video about end caps in square steel tubing
      Not sure if this is the one u had in mind but. Here is the one I found. If it isn't what u found would u post your video

      http://youtu.be/wNM6wTeUgyw

      Comment

      Working...
      X