Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

box/pan brake ideas

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • box/pan brake ideas

    I'm looking to fab my own box/pan brake. viewed some pics of some that were very well built but no details. anyone out there have some good pics or prints for a box/pan brake? I'm looking at the idea of a 4 ft table top or floor mounted that can bend up to 11 gauge. thanks

  • #2
    I am looking for a 4' pan brake. I have limited funds and I cannot find anything used. If someone knows of a good auction site or other resource I would greatly appreciate it.

    Comment


    • #3
      I saw great ideas on youtube.

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.