Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Built a roof rack for my EZGO golf cart

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Built a roof rack for my EZGO golf cart

    I had been wanting one for tackle bags, beach chairs, coolers, etc but didn't want to pay for one so I thought I'd build it myself. I don't have much in it and I think it turned out nice. Would've liked the bottom to be Aluminum diamond plate but at 110$ a sheet I passed in favor of the 6" wide aluminum junkyard finds. I think it turned out pretty good...
    Attached Files

  • #2
    Nice. Who makes EZGO. Is that Yamaha.

    Comment


    • #3
      EZ Go is made by EZ Go....

      Comment


      • #4
        Nice job on the roof rack. Just be sure to not overload as your roof supports are only aluminum square tube and could collapse under too much weight. Ouch...

        Comment

        Working...
        X
        Special Offers: See the latest Miller deals and promotions.