Announcement

Collapse
No announcement yet.

mm250x gas solenoid

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • mm250x gas solenoid

    does anyone know of a way to diagnose whether the gas solenoid on the millermatic 250x is defective? I would like to isolate if the problem is with the solenoid (an easy replacement) or with the signal getting to the solenoid. (a trip to the repair shop). I am not getting gas delivered to the gun. There is gas getting to the solenoid but not beyond this point. I am not hearing anything at the solenoid such as a tell tale click that the device is opening when I depress the trigger. any ideas would be appreciated.

  • #2
    llawry,

    Check for 24 volts AC to the valve with the gun trigger pulled. If it's there and the valve is not pulling in then you have a valve problem.

    Kevin
    Kevin Schuh
    Service Technician
    Miller Electric Mfg. Co.

    Comment


    • #3
      solenoid

      I thought this might be the case but was looking for confirmation. Thanks. I will test on the unit and with an independent 24volt power source. If this is not the problem, I will take to the local dealer for service as I did not see any evidence of a fuse or anything else that is within my capability to trouble shoot.

      Comment

      Working...
      X