I'm plating the frame of a F250 Ford Super Duty and will be installing a 'Sneeker' repo wheel lift on Monday. I normally remove all items from the frame rails and cut 1/4" plate for this job. Customer provided 3/8" plate, and I had to cut 5 pieces for each side. The 3/8" is too thick and would have required I move the spring pads on the axles. Considerable rust had to be dealt with at this used to be (and still is) a plow truck. Former owner carried salt in bed. I plasma cut all the plates and welded them to each section by MIG. I profiled the plates to match the profile on the spring hanger brackets. I recently rebuilt the Sneeker so he should have a good to go repo rig by next week.
No announcement yet.