Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

My Wood Processing setup

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • My Wood Processing setup

    I acquired an old, super heavy, 3 pt hitch log splitter a few years ago. It only could be operated from the hydraulic lever on the tractor. I modified it by adding an axle, spool valves for the hydraulics, a retractable tongue so I can haul the thing with my 'Buzz Saw' attached. At first I had no log lift, but added that last year. The buzz saw was completely redone. Installed the safety guard around the blade, added a right angle gear box, pto shaft (was originally driven with a flat belt, then a small engine was added), beefed up the frame, etc. Thing works great.Name:  3acdf9ca2b67274af2fee20f7ba0b1ac.jpg
Views: 1
Size:  83.4 KBName:  59f8eb1342990ec6eb35bc65c29f517c.jpg
Views: 1
Size:  266.2 KBName:  97e2a40f11529fd3fc2352f631893996.jpg
Views: 1
Size:  77.4 KB

  • #2
    Nice looking setup; well done
    Harold

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.