If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Picked up the Pass Port Plus last week. This week I want to get the spool gun for it. What all do I need to run aluminum on the Pass Port Plus? Spool gun, gas and wire? What type of gas for the aluminum?
Last week I got my 5th PassPort + and they all weld just about the same.
When you startout with the PassPort + you'll need to start on the low side of the rrecommended settings. The little PassPort + has alot of power and I find the factory settings are kinda high. Also, when you adjust the machine, I have found that the adjustment knobs are VERY sensative. Each little click makes a big difference.
5 Passport Pluses
2 MM 212's
MM 251 MIA
MM 350 P w/Python
w/ tig runner
2 Black BWEs
Star & stripe BWE Digital
2 star & stripe xlix's