If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The last alum tubing i bought in that size was 28 bucks for a 12' stick and i am sure its higher now. I would figure how much for the tubing than times it x 3 for welding it up. Sounds like you have a bunch to make...Bob
Three Times The Material Cost For Mig Welding. Five Times The Cost For Tig Welding. Additional One Time Charge To Fabricate Jigs And Fixtures. If You Have The Ability And Can Do The Job, Get Paid For It. We Dont Take On These Projects Because We Need The Practice. Do A Quality Job On Time And You Will Have All The Work You Can Handle, And You Will Be Componsated For Your Skill.
i think it looks a lot easyer than its going to be, jigs are going to be a must. i like DOUG SHAUGHNESSY outlook on it.
thanks for the help
hope i helped
feel free to shoot me an e-mail direct i have time to chat. firstname.lastname@example.org summer is here, plant a tree. if you don't have space or time to plant one sponsor some one else to plant one for you. a tree is an investment in our planet, help it out.
Thank you guys I figured that it would take about 6 tubes to make it plus some 1/4 inch plates for the casters base. A fitter and a welder (that one would be me) for a total of $1,690.00 per table frame including casters and fob my shop. Waiting for the client to reply wish me luck!!!!