If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
for the tire foam stuff we got a two part stuff from john deere dealer took valve cores out tire. mixed up stuff poured through valve stem and let it do its thing after 20 minutes or so snipped the stuff that had squirted back out and had a solid tire. it was the caster wheels on the front of a large mower after the tires fell apart we were still able to run the foam rubber wheel for a few days.
My father-inlaw asked me to make him an aluminum shoe rack for xmass.
It is framed with 3/4" x 1/8" square tubing and the runners are 3/4x1/16" angle. I had a hard time trying to present it in photo's but here it is.
Oh, btw, the cat is my biggest fan.
I build the engines for an Alfa Romeo spider that we've been running at Bonneville for the last 10 years. We started with an Alfa transmission, but quickly found out that it couldn't handle the horsepower of the turbocharged engine . . . so the replacement (Muncie M22) required a custom bellhousing. I also decided to move the starter behind the ring gear to make room for a larger intercooler.
Here's the finished product . . . made from 1/4 inch mild steel.
Now this one is really cool.Does it have a door somewhere that locks?
sorry it took so long to get back but im not to up on how this works. yes it has a door no lock needed in my location though. i built it because i never knew where to look for any packages. sometimes in my other truck or one of the out buildings or in middle of drive. will post with door open ,hope pic is not to big.