If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Lincoln ac/dc 225
MM200 black face
Whitney 30 ton hydraulic punch
Lown 1/8x 36" power roller
Arco roto-phase model M
Vectrax 7x12 band saw
Miller spectrum 875
30a spoolgun w/wc-24
Nice job. Did you do these in the shop, laying it out on the floor or onsite?
Funny you ask,i did the lower section in the shop and it kick my a$%.So for the heck of it i fabricated the the top section in the field and it took alot less time.Lot easier to get things right when your putting it together were its staying.If i had to do it all over both would have been done onsite.
Looks like a real fine job you did on those rails. Just wondering how long it will be before some fool skate boarder trys to slide down the rails and jump the gap between them. Probably see those rails again on an episode of "America's Dumbest" when he fails miserably on the stunt.