Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Bed Riser

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Bed Riser

    I was looking at a catalog today for bed risers. I had a set of 4 under the bed but with my bed being an adjustable bed, they did not hold up to the weight. I was looking at wooden ones when my mind went into gear and said "Make them out of metal dummy" so I did. Only an hour to make 4 of them from scratch. I used 1/4" x 4 x 4 tubing that I had on stock and 2" angle iron for inside that the wheel fits into perfectly, I also put a 4" flat on the bottom so the edge did not cut into the carpet. They are 5" high and make the bed just the right height.

    I also included a pic of another plow dolly I made on Friday.
    Attached Files

  • #2
    Hey Ken,
    I like those Risers. . . you did a good job



    ........... Richard

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.