Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Power wheel chair armrest

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Power wheel chair armrest

    I made this a little while back for one of my players.
    With his spasms he wanted an armrest with a higher outside "wall" to keep his elbow from hopping off the rest. This is what I came up with.

    This was the first design:

    This is the re-design for better keeping his elbow affixed:

  • #2
    and some more:

    So that's how you keep an elbow planted on a chair!! haha

    For some reason I can't find pictures of how I mounted it to the chair post, but I put two holes in the bottom plate and welded nuts on the bottom so we didn't have to worry about losing the nuts with the arm rest. It has also been padded out with some 1/8" rubber


    Special Offers: See the latest Miller deals and promotions.