Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Aluminum boat prop repair.

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Aluminum boat prop repair.

    I have done lots of these in the last 35 years but never took any pics. I worked in a marina this summer and met some "future" clients who needed props done and they said they would call when the boats came out for the winter. Well one called and here are a few pics. It was an easy fix with not much damage on the edge (but i didn't get a pic of the bad area). I layed it on a steel plate and built it up with my Miller spool gun and .030 4043 alum wire then polished it off with a flap wheel. Ready for the next one...Bob
    Attached Files

  • #2
    Nice work as usuall Bob. Keep it up.Wayne


    Special Offers: See the latest Miller deals and promotions.