Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

212 Postion Jumper Links - input voltage?

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • 212 Postion Jumper Links - input voltage?

    While setting up 212 for the first time I ran into postion jumper links question, input voltage 200 or 230? Do i need to buy a voltmeter to check?

    I have 200 amp service, it has a 30 amp breaker with # 8 wire I use for my thunderbolt and plasma cutter. Will that work? I plan on installing a 40 amp breaker with #8 for the 212. Am i on the right track?

    Any help would be greatly appreciated!

  • #2
    If this is in your residence/home shop than your service should be 230/240v if you are in the US.

    #8 wire & 40 amp breaker will be fine.
    Last edited by MMW; 09-24-2011, 04:08 PM.

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.