Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Mig welding around old brazing and lead panels?

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Mig welding around old brazing and lead panels?

    Made some repair panels for my 33 Chevy coupe. Noticed that the areas where I plan the butt welds have a lot of old brazing joining the panels. The lead is easier to remove...but is there a special procedure to follow before starting the mig around brass? The car is 18 ga and the panels I made are also 18 ga.

    Thanks



  • #2
    You have to get rid of the brass, I'de use a little die grinder. Takes time.

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.