Announcement

Collapse
No announcement yet.

DC Polarity

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • DC Polarity

    What are the main differences in actual welding between, Straight Polarity
    (electrode -) and Reverse Polarity (electrode +).

  • #2
    i am a student and we have just learned about that and basically it differs from which welding process your doing for example tig the heats shoots right up through the electrode when your welding with striaght polarity but that is what my teacher was telling us!!

    Comment


    • #3
      Main difference

      Reverse polarity, DCEP, promotes more penetration

      Straight polarity, DCEN, promotes mild penetration

      (A/C is somewhere in between.)

      Hope this helps.
      Triggerman

      Ammonia refrigeration tech
      Trailblazer 302 (yes, it's new)
      Millermatic 180 w/Autoset
      CST-250
      HF-15 High frequency
      XR15 w/Push-Pull Gun
      Victor O/A, DeWalt, North mask


      "A professional knows what to do. A craftsman knows why."

      Comment


      • #4
        Thanks Triggerman, a very helpful answer.

        Comment


        • #5
          I depends on what process you are using. With Tig, DCEN is used for welding ferrous metals, while AC is used for welding most non ferrous metals such as Aluminum

          With GMAW, DCEP is the only polarity that can be used. With Fluxcore wires, the polarity will depend on what type of wire is being used.

          With SMAW, various rods use different polarities. In general however, rods run on DCEP provide more penetration while those run in DCEN provide less. However, this is just as much a case of the type of flux used on the rods as the polarity.
          Dynasty 200DX, first generation
          Makita 5" grinder
          Makita 14" abrasive saw
          IR SS5L compressor
          Whole bunch of hand/air tools.
          and a wish list a mile long

          Comment

          Working...
          X