This is the result of 4 rods of 1/8 6011 on some 1/4 steel. For size reference, the piece is 6" wide. I just quickly went over them with a knotted brush on my grinder. I realize they aren't completely clean. Before I ran the beads I did go over the steel with a flap disc and got it mostly clean. The top bead was my last rod and I had it set at 90 amps. The second from bottom with the large crater at the end was set at 105 amps. The second picture is a closer up of the top bead. Please critique.
No announcement yet.
Pictures of my first welds!