Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

vertical up

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • vertical up

    hey my name is Dan Cole and i am a student at a technical school and i am running 7018 3/32" at 85 amps vertical up does anyone have any suggestions? Thank You
    Last edited by dancole; 01-26-2008, 07:25 PM.

  • #2
    Welcome to the board Dan, you came to a good place for some great answers. We also love to see pictures, the more the better. May I ask what part of Pa you are in ?

    As far as vertical up....

    Practice, practice and more practice. That is a tricky method and mine are still not as pretty as a lot I've seen. I'll let somebody else give you better details than I can. Do keep your rod at the right angle and don't have your amperage too high.
    Last edited by KBar; 01-26-2008, 07:20 PM.

    Comment


    • #3
      7018 uphill

      When my LoHy gives me problems uphill, I switch from the usual drag to a step (pipe) or weave (plate). Nothing too big, just enough to help the freeze. And like Kbar said, watch your heat. Hope this helps.

      Comment


      • #4
        Welcome;
        My advise is to treat the center of the weld area like the "no stopping" zone at an airport, and the edges (toe) as the "unloading zone" only at this airport we never stop we get to kick the inlaws from the moving car and be on our way.

        By doing a slight weave left to right and back never stopping in the center you create a shelf of slag and new weld material for the next weave to sit on.

        "So in a way the vertical up is just o series of short horizontal welds laid on top of each other"? No but yes sort of in the vertical up it is one continuous weld. Done well it will have the stack of dimes look.

        Hope this helps

        Luck

        Comment

        Working...
        X
        Special Offers: See the latest Miller deals and promotions.