Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.


Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Projects

    Havn't been on lately but time has permitted a couple of small projects.
    A small stationary angle grinder and storage space for vise grips and clamps. A garage sale find brought an old VIEL lathe, had a 3/4 hp motor in "stock" some scrap tubing and I have a new tool. The lathe spindle just happened to be 5/8 thread same as an angle grinder, spin on a 9 in disc or whatever fits and go hard. The table is adjustable for angle work. The storage drawer was wasted space so a couple of salvaged slides ,angle iron and plywood painted white for visability makes for quick access to the clamps.
    Attached Files

  • #2
    clever use of an old tool

    Good idea. Wood lathes seem to be pretty inexpensive on CL.


    Special Offers: See the latest Miller deals and promotions.