If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
You might get by with a 40 amp breaker if you don't push the machine, I would recommend to get a 60 as asked for since you are going to need to wire anyway.
Hobart Handler 210 w/DP3035 - Great 240V small Mig
Hobart Handler 140 - Great 120V Mig
Hobart Handler EZ125 - IMO the best 120V Flux Core only machine Miller Dynasty 200DX with cooler of my design, works for me
Miller Spectrum 375 - Nice Cutter
I would sy be sure your lines can hold a 60 amp... to many times i hve seen people overloading there lines tthat come in to the breaker box. turn everything on in your shop and get a amp probe and be sure you have room for another 60 amps..