Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Recent Project

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Recent Project

    My wife wanted a trellis for some vines to grow on.
    This is what I came up with...

    The uprights are 1" sq tube,
    The rings are 1/4" round bar that I rolled into rings
    with a harbor freight cheapo ring roller --- once I got the
    diameter I wanted, it worked ok, but getting it dialed in was
    a pita...

    I didn't finish it at all -- I'm just letting it rust.


    p.s. some may recall that a few weeks ago I asked about welding cast-iron
    to carbon steel. This was the project I was going to do it for. We decided not
    to go that route (for now). Thanks to those who answered my question.
    Attached Files

  • #2
    Nice, man. Really distinctive. Bet she's happy!


    Special Offers: See the latest Miller deals and promotions.