If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I finally bought a Weldsale welding table. It has 1 3/4 holes. Has anyone else fabricated their own clamps for holding down tubing? I have my ideas but wanted to see if anyone built and used anything ingenious?
I took some large c-clamps that I bought at an auction and I cut them off and welded them to a 1 1/2" pc of solid round stock, I placed a small weld on the bottom to act as a catch. You could do the same thing with those bessie slide clamps