Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

New Syncrowave 200

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • New Syncrowave 200

    I need to install a outlet for my new welder, What would be the best amp breaker I should use? Could I get by using a 40amp Breaker?

  • #2
    You might get by with a 40 amp breaker if you don't push the machine, I would recommend to get a 60 as asked for since you are going to need to wire anyway.

    Comment


    • #3
      I would sy be sure your lines can hold a 60 amp... to many times i hve seen people overloading there lines tthat come in to the breaker box. turn everything on in your shop and get a amp probe and be sure you have room for another 60 amps..

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.