Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Pressure relief Line & Spool

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Pressure relief Line & Spool

    Built this a few weeks ago, just getting around to adding pictures. Fab'd it up in two and a half days, just me and a helper. I think it was 30 butt welds and 6 T.o.L. plus 2 tie in welds a few days later. Nothing really jumped when we unbolted the old spool so it fit pretty good.

    Rebuilt the 8'' spool (first 2 pictures) to make tie-in easier and faster (less down time). Last to pictures are of the 6'' pressure relive that comes off the 8'' and drops into another 6'' after clearing existing piping.
    Attached Files
    Last edited by Rig Hand; 05-13-2011, 11:41 AM.

  • #2
    Plenty of rollouts there righand, a nice little gig for two of you. Vantages just love that kind of work! Bob.


    • #3
      Nice job Rig Hand, I love seeing how the pros work.



      Special Offers: See the latest Miller deals and promotions.