Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Buckle

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Buckle

    This is a buckle I made for a customer. It's the name of his company. It is made out of 10ga. steel with a 1/8" pin for the belt latch and a 3/16" staple that the belt attaches to. I overlayed it with 22ga. german silver.
    Attached Files

  • #2
    Any chance you have some photos of the back? Just curious to see the "mounting hardware" that you described.

    I've done a couple of buckles, but I have always struggled with the "mounting".

    Later,
    Kev

    Comment


    • #3
      Very nice!

      Comment


      • #4
        I don't have a picture of the back of the buckle, but i am working on another on and will post the photo of the back when I'm done.

        Thanks
        Tubby

        Comment


        • #5
          Nice work Tubby, I like the detail.

          Gord

          Comment

          Working...
          X
          Special Offers: See the latest Miller deals and promotions.