If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Miller 330 BPA - Sold
Miller 180SD Syncrowave - Sold
Miller Aircrafter 330ST - Sold
Miller 351 Syncrowave - Sold
Miller Maxstar 150 STL
Miller Dynasty 200 DX
Miller 135 Millermatic
Miller Spectrum 250D (Now running strong!)
It's designed to draw water through the filters at the bottom of a tank filled with some type of crushed rock. Part of a water filtration system. Entirely 316 ss and has to match threaded rod that is welded to the bottom of the tank which was welded by a supplier before rubber lining. Meaning, someone else welds the tank and then it gets rubber lined. Then I had to build that ring assembly with the bolt hole pattern already in it and make the entire assembly fall together without use of pry bars and come alongs. Because the whole thing gets assembled inside the tank. This is just a pre-assembly to prove it fits.