Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Maxstar 150STL Trigger Methods.

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Maxstar 150STL Trigger Methods.

    Page 9 of my Manual describes the process to set the trigger method as below

    Trigger Methods Choose between:
    Standard (remote amperage and output control), which is the factory default, or Lift Arc Panel Control (for use without a remote control or with remote amperage but without output control).
    The trigger method that was active when the machine was last turned off will be active when unit is turned back on. To change trigger method, enter set-up mode as illustrated:


    I have a RCCS-6M Thumb controller with current control and contactor. Which way should I set the Maxstar to use the RCCS-6M.?

    What is the difference between the 2 models, given that it seems both modes will provide remote amperage control?

    (It's the with remote amperage but without output control note above the confuses me as I thought remote amperage was output control )

    IAppreciate the help - It's working now so I won't mess with it - but I'd like to understand the real difference in the 2 modes. Not knowing things just bothers me

  • #2
    Hope this helps......

    RCCS stands for Remote Current and Contactor. You should set your Maxstar for Standard mode (the top indicator). Output control determines whether the weld output is on or off. The current control sets the output current from 0 to the setting on the panel.

    Best of luck. I hope you enjoy your Maxstar as much as I enjoy mine.

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.