Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Inverter impressions (XM304)

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Inverter impressions (XM304)

    Back in Nov I purchased a Red-D-Arc EX300 Inverter (that's an XM304 to ya'll). I cannot express how impressed I am with this machine. I am no fan of single process machines to begin with. That just means you need more of them. I had never had the opportunity to use a machine with arc force control before and boy do I wish I had. I use it primarily as a power source for a suitcase wire feeder with fluxcore, but have done some stick work with it. It weighs about 75 pounds and can crank out 160 amps all day long without a break on single phase 220. I think it is 250 amps at 100% duty cycle on three phase power. That is the only drawback I can see so far and I would really like to see Miller do something about it as it looks like the next one will be a Lincoln for that very reason. I need the extra power. I wouldn't recommend it for a beginner or hobby welder, unless you really want to spend a boatload of money, but if you are a pro it's well worth looking into. The only thing this thing can't do with the proper accessories is AC.

    I also picked up a Lincoln AC-225 (I think it says Lincwelder on the label). This thing is so old the paint has turned dreamsicle orange. It actually belonged to a friend of my fathers (they grew up together, got married in a double ceremony - I guess you could call it lifelong friendship) who passed away from cancer a while back. His wife told my dad to take it to me as she had no use for it and didn't know if it even worked. Well it works and welds better than the new one I bought last year for skinning trailers. It weighs about twice as much too. Sometimes old isn't a bad thing.

  • #2
    Where i used to work they gave me a blank check and said go buy whatever you want. So i bought an XMT304 ,S22 wire feeder and a bunch of cable. Great machine in mig mode or stick. Wish i had one, but its on my list...Bob

    Comment


    • #3
      I've run quite a few XMT inverters in the past and I'd have to say that next to the Dynasty line up that it's the smoothest inverter I've ever run and also one of the most reliable inverter power sources.

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.