Announcement

Collapse
No announcement yet.

Little help regards Syncrowave 300

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Little help regards Syncrowave 300

    Got an older Syncrowave 300....built in 1985, Single Phase...and want to hook it up 230 Volts.

    The manual shows hook up is 2 hots.....My supply is 2 hots, a neutral and ground.

    I can figure out the ground...but what should I do with the Neutral wire?

    Anyone out there familiar with this older machine?

    Thanks

  • #2
    The neutral is not used in your application. The grounded conductor is attached to the frame of the machine. There should be a lug for this purpose close to where the two hot wires connect.
    XMT-300 with S-64 wire feeder.
    Lincoln HI-FREQ modified to run XMT.
    Esab PCM-875 plasma cutter.
    Miller Spoolmatic-1
    Miller PC-300 pulser
    Miller Optima pulser

    Comment

    Working...
    X