Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Miller Auto Invision II

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Miller Auto Invision II

    I have a miller auto invision two with a panasonic controller, it is about twelve to fifeteen years old and has never been refurbished. It is getting to wear that when it welds aluminum the weld isnt fully welding the material and the weld is just sitting on top. I have played with the feed/speed and voltage settings on it. Any suggestion of things that I may could do to improve the efficiency of the machine without refurbishing it. I know that it needs refurbishing but I cant afford it right now.

  • #2
    A little more info is needed. What gas you are using, what voltage, what wirespeed. Possibly your ground clamp is poor, possibly contact tip is poor/ not sized right for your wire.

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.