Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.


Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Reels

    Just wondering if anyone has any plans for reels or wants to post some pics of theres.

  • #2
    Originally posted by AmericanWelder View Post
    Just wondering if anyone has any plans for reels or wants to post some pics of theres.
    here are the pix's of my, I made then my self, the 002 are the rolls, the 004 is the stand extended, the 003 is the stand retracted and the 001 is the close-up of the positive (+) roll.
    Attached Files
    Last edited by thewelder; 01-07-2011, 11:26 PM.


    • #3
      Heres some pictures of mine

      I used a different approach using the tweco disconnects as i use a hi freq box and dont want any kind of jump from the leed reels to ground out anywhere , the locking mechanism is a very simple pin with a spring and a hole with a roll pin in it and two pieces of rod inside the 2 inch tubing u pull it and twist 90 degrees to unlock them and twist 90 and they lock , i have since built a oxy acet reel for the top of it
      heres a link to estimate the capacity of the reels
      Attached Files


      Special Offers: See the latest Miller deals and promotions.