Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

snapon ya217 help

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • snapon ya217 help

    i have Snap on YA217 that is 120 volts mig. i hooked up an argon tank to it and i was wondering what the psi was that i sould be welding ith like 10 -35 numbers.
    and does anyone have any info on this welder?

  • #2
    i know not of the welder,but using this type of gauge i would say around the 10 psi range indoors,and a little more if a slight wind is present .dont care much for this type of guage,prefer flow meters that have the floating ball to give you a better perspective of flow rate.


    • #3
      I had one back when I was 18. Good little welder for sheet metal. I had really used the heck out if mine. It had the spot/ stitch feature., real handy for long quarter panels.
      I don't recall what style gauge it had tho.
      Last edited by tnjind; 01-02-2008, 03:40 AM. Reason: spelling


      Special Offers: See the latest Miller deals and promotions.