Announcement

Collapse
No announcement yet.

More Dirt Bike Chassis Repairs

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • More Dirt Bike Chassis Repairs

    This was a chain roller guide.
    When the nylon roller wears down no one seems to replace them and the end result is the roller guide gets ground down.
    A few hours later in the workshop a whole new bracket and roller guide ready to weld on the frame.

    Ji
    Attached Files
    Last edited by Jigantor; 12-12-2010, 08:44 PM.
    Grip it and Rip it

  • #2
    I bet this repair is going to cost more than just routine maintenance. Plus the dude has to get the nylon roller too.
    MillerMatic 252
    Spoolmate 200
    Diversion 165
    Spectrum 625 X-Treme
    Dayton 6" Miter Band Saw
    Delta Drill Press
    Bosch 10" Table Saw
    Bosch 12" Double Bevel Miter Saw
    Jet 5 Ton Chain Hoist
    Radnor O/A

    and this heavy duty table I made

    sigpic

    Comment


    • #3
      Yep
      The nylon roller only costs $5.00.
      I will never get it.

      I have the OEM roller but may lathe a custom one just to finish the repair with a little extra bling.


      Ji
      Grip it and Rip it

      Comment


      • #4
        So I could line the new bracket up in the right spot I made a very basic jig.
        This should also hold the bracket while I weld it onto the frame.

        Ji
        Attached Files
        Grip it and Rip it

        Comment

        Working...
        X