If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Where is a good place to purchase dryers for my new plasma cutter? How many are recommended in series to insure quality filtering?
A Motor Guard M-26 with 4 extra filters is $101 from IOC, or you can normally get a M-30 filter off ebay for lots cheaper (from the information I have they are the same). One should be enough I would think, maybe others would recommend more but I don't have any humidity here to speak of and the one motor guard works fine for me. Check this link for more info on this http://www.millermotorsports.com/mbo...=plasma+filter
Hobart Handler 210 w/DP3035 - Great 240V small Mig
Hobart Handler 140 - Great 120V Mig
Hobart Handler EZ125 - IMO the best 120V Flux Core only machine Miller Dynasty 200DX with cooler of my design, works for me
Miller Spectrum 375 - Nice Cutter